|
|
 |
| Troubleshooting |
|
Adding TCP/IP protocol |
- Go to the control panel and select network..
- Click Add.
- If TCP/IP is installed, you're all set and can move on to Installing Dial-up Networking. If not, in the network protocol list, click on TCP/IP protocol and click on OK.
- Insert your Windows NT distribution files and then click Continue.
- Restart the computer.
Installing/Configuring Dial-up Networking
|
- Double click on My Computer.
- Double click on Dial-up Networking.
- Click Install and follow the on-screen instructions. If the Install button is unavailable, then Dial-Up Networking is already installed, and you can quit this procedure.
- If it is your first Dial-Up Networking connection, just follow the instructions on you screen, if not click New.
- In the Entry name box, type Ziplink
- Check I know about dial-up networking and settings directly.
- In the Phone number box, type the number provided to you by Ziplink.
- In the Dial using box, click a modem, and use the default modem configuration.
- Click the server tab.
- In the Dial-up server type box, click PPP.
- Under Network protocols, select TCP/IP.
- Make sure enable PPP LCP extensions is "NOT" checked.
- Click the TCP/IP settings button.
- Click on Specify name server addresses.Primary DNS: 206.15.168.65Secondary DNS: 206.15.168.69
- Click on OK
- Click on the Script tab
- Make sure "Run this script" is set to "None" and click OK
- You're done! Right click on the Ziplink icon to Dial in.
|
|
